Tailscale Remote Access
checking…
One-time setup needed
This system doesn't allow ChitUI to install software on its own (passwordless sudo is disabled). Run this single command over SSH — it installs Tailscale and grants ChitUI permission to manage only the Tailscale service:
-
After it finishes, come back here — this page will update automatically and everything else is done from the web UI.
Install Tailscale

Tailscale creates a private encrypted network (tailnet) between your devices. Once installed and logged in, you can reach ChitUI from anywhere — no port forwarding, and the Pi stays invisible to the internet. 


                

            

        

    


    
    

        

            

                

                    

                        Connect to your tailnet
                    

                    

                        Tailscale is installed but this Pi is not logged in yet.
                        Start the login and then open the link (or scan the QR code)
                        with any device where you are logged into Tailscale.
                    

                    
                    

                        
                            Open auth link
                        
                        

                            Auth QR
                        

                        Waiting for authentication…
                    

                    

                

            

        

    


    
    

        

            

                

                    

                        

                            Tailscale IP
                        

                        
-
                            
                        

                        -
                    

                

            

            

                

                    

                        

                            MagicDNS
                        

                        

                            -
                            
                        

                        works if MagicDNS is enabled
                    

                

            

            

                

                    

                        

                            Account
                        

                        

                            -

                        
                            0 peers online
                    

                

            

            

                

                    

                        

                            Actions
                        

                        
                        
                    

                

            

        


        

            

                

                    

                        

                            Connect ChitUI Remote (Android)
                        

                        

                            

                                
    
                                    
  1. Install the Tailscale app on your phone
                                        and log into the same account.
    2. 
                                    
  2. In ChitUI Remote, set the server address to:
    3. 
                                

                                

                                    -
                                    
                                

                                
                                    Camera stream, notifications and file upload all work
                                    through the same address, from anywhere.
                                
                            

                            

                                Server QR
                                
scan to copy address