Each leak detector module (ESP32) is tracked separately - useful if you have one per printer.
A module appears here automatically the first time it reports in; rename it so alerts say
which printer they're from instead of just showing an IP address.
No modules seen yet. A module will appear here as soon as it sends its first status update or alert.
Note: Sensor configurations are used for display purposes.
The ESP32 device handles actual leak detection logic and thresholds.
Relay Safety Shutoff
GPIO not available - running in simulation mode
Activate Relay on Leak Detection
When enabled, the relay will automatically activate when a leak is detected.
The relay stays ON even after system reboot until you manually disarm it.
Use this to cut power to your printer or activate an alarm.
Select the GPIO pin connected to the power relay
Match your relay module's configuration
Relay Status:Disarmed
ARMED: Armed at:
Push Notifications
These notifications are sent via the Chitu Notify plugin.
Configure your notification topic and service in the Chitu Notify settings.